| |
|
Company Profile
Keyence - Microscopes Laser Marking, Barcode Reader, Safety Light Curtain, Laser Sensors, CCD Camera
Stock Symbol 6861 (Tokyo) KYCCF (ADR)
1-3-14 Higashi Nakajima
Higashi
Yodogawa ku, Osaka 533 8555 Japan
Phone: 81 66379 2211
Fax: 81 66379 2131
www.keyence.com
|
| Fiberoptic Sensor, Manual Calibration Sensors, High Speed Response |
Fiberoptic units shown in products below are but a small sample of FU's available. Please use the following Fiberoptic Units links to determine the FU your application requires. These products are also listed under the Fiberoptic Senor Units for Keyence. Contact OEM for Fiber Units compatible with each series.
Light source Red LED
Sensitivity adjustment/ Mode selection 8-turn trimmer (with indicator) FINE/TURBO switch-selectable
Response time 250 µs (FINE), 500 µs (TURBO) 250 µs (FINE), 500 µs (TURBO) 250 µs (FINE), 500 µs (TURBO) 410 µs to 1.2 ms 1.
Operation mode LIGHT-ON/DARK-ON (switch-selectable)
Indicators Output indicator: Red LED
Stable operation indicator: Green LED
Timer function ON-delay: 40 ms, OFF-delay: 40 ms, Timer OFF (switch selectable)
Control output NPN or PNP:100 mA max. (40 V max.) Residual voltage: 1 V max. 2.
Stability output NPN or PNP: 50 mA max. (40 V max.) Residual voltage: 1 V max. 3.
Protection circuit Reversed polarity protection, over-current protection, surge absorber
Power supply 12 to 24 VDC±10% 4.
Current consumption 35 mA max.
Ambient light Incandescent lamp: 10,000 lux max. Sunlight: 20,000 lux max.
Shock Resistance: 500 m/s2 Three times each in X, Y, and Z directions
Vibration: 10 to 55 Hz, 1.5-mm double amplitude, each in X, Y, and Z directions for two hours
Ripple 10% max.
Please select individual skus for mechanical drawings
The FS-T0/M0 have no control output
Only the FS-T1/M1 provide stability outputs.
Stability outputs for the FS-T2/T0/M2/M0 are output from the FS-T1/M1 or FS-R0.
Power to the FS-T2/T0/M2/M0 is supplied through the FS-V1/T1/M1 or FS-R0. |
|
